My question is this: Sep 28, 2015 34,688 Salem, Oregon.
New posts. Now if the hub is good I would be inclined to not throw parts at it but that's up to you.
Open the jaws of your vice just wide enough to support two of the ears as shown in Photo 3. Jerry Bransford said: Upgrade City by 87Raider.
Nov 9, 2015 9,565 Escondido California. Members Current visitors Supporting Member Upgrade. Check out this thread to see how. Mitsubishi Tech from 4x4Wire Read More. Pound on the thick part of the shaft, just to the inside of the cap to begin backing the cap out.
The clip is almost off in this photo.
All corporate trademarks are the property of their respective owners. I like the idea of new unit bearings too as these are probably original. Photo 1: View attachment 45256. If you are asking that question you have obviously never dealt with severely rusted joints from an older street driven Jeep that's never been in 4wd and has an open knuckle front end.
Log in. Step one is to remove the 4 C-clips that hold the caps in place. Did the rear shaft last week.